







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cabinets & Countertops in Walnut Creek: What the Job Actually Costs and Takes
Cabinets & countertops in Walnut Creek typically run $14,000 to $45,000 for a full tear-out and replacement, with most jobs landing in the middle of that band. Plan on about three weeks from demo to final caulk: two weeks of build and install, plus a week of template, fabrication and inspection. Call (855) 471-4163 and we’ll walk your kitchen, measure it properly and put a line-item number in writing.
How We Take a Walnut Creek Kitchen From Old Cabinets to Finished Tops

Cabinet and countertop work has a fixed rhythm. Skip a step and something doesn’t line up later, so here’s the real sequence and what you’ll be deciding at each point.
Stage 1: Measure and finalize layout (day 1, about 2 hours)
We take field measurements rather than working off your old drawings, because walls in this housing stock are rarely square. This is where you lock in the layout: where the sink sits, which run gets drawers versus doors, and whether the range stays put. Anything you change after this meeting costs more than anything you decide now.
Stage 2: Demolition and rough prep (days 1 – 3)
Out come the old cabinets, countertop slab, backsplash and any warped subfloor. We patch drywall, check that the walls are plumb and shim where they aren’t. If we find water damage around the sink or a dishwasher leak, that gets framed and repaired now, not covered up. You’ll see photos of what’s behind the walls before anything goes back.
Stage 3: Cabinet installation and leveling (days 3 – 6)
Base cabinets set first, then the uppers, all leveled and screwed to studs. Fillers and end panels go in. This is when you confirm door style and hardware placement, and it’s the last easy moment to add an outlet or a drawer base. We leave the range and dishwasher bays open until the countertop is down.
Stage 4: Template and fabrication (days 6 – 14)
A fabricator templates the counters once the cabinets are set. Some shops use digital templating, some use physical templates; either way you’ll pick your edge profile and slab at this stage. Stone fabrication takes about a week from template, laminate and butcher block are faster. Any sink cutout, faucet drilling or cooktop opening gets specified here.
Stage 5: Countertop install and final walk (days 14 – 21)
Slabs go down, seams get epoxied and polished, sink and faucet get set, and we run water to check for leaks. Final walk covers drawer alignment, door reveal, caulk lines and any touch-up. You sign off only when it’s done, and the workmanship sits behind our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Cabinet and Countertop Choices You’ll Weigh
Most of the price swing on a Walnut Creek cabinets & countertops job comes down to a handful of decisions. Here’s the honest read on each.
- Stock vs. semi-custom vs. custom cabinets. Stock sizes are cheapest and fastest but leave gaps that need filler panels. Semi-custom (KraftMaid is the workhorse here) gives you real size options and better finishes without custom lead times. Full custom suits odd footprints but adds cost and weeks.
- Paint, stain or thermofoil doors. Painted MDF faces look sharp and hold up in dry interior air like we get on the east side of the hills. Thermofoil is budget-friendly but can peel near a dishwasher or oven over time. Stained wood hides scuffs better than paint.
- Quartz, granite or laminate counters. Quartz is the default now for its non-porous surface and consistent color. Granite is durable and each slab is unique, but it needs sealing. Laminate still makes sense if the budget has to stretch elsewhere.
- Slab thickness and edge. A 2 cm slab on a built-up edge costs less than a 3 cm slab with a mitered edge. Mitered edges read as “thick stone” and add real dollars.
- Undermount vs. drop-in sink. Undermount looks cleaner and makes wiping easier but costs more to cut. Drop-in sinks are simpler and cheaper to install.
What Cabinets & Countertops Costs in Walnut Creek, CA

A full cabinets and countertops replacement in Walnut Creek is $14,000 to $45,000 for the lead scope here. Smaller kitchens and partial swaps sit lower. The line items we typically quote:
| Line item | Typical range |
|---|---|
| Cabinet installation (full run) | $4,000 – $13,000 |
| Countertop installation (quartz, granite or laminate) | $2,000 – $6,500 |
| Backsplash (if you’re doing it with the counters) | $800 – $2,500 |
| Kitchen island install | $3,000 – $10,000 |
Four things push a job to the high end: overall kitchen size and cabinet count; what’s behind the walls (hidden water damage, out-of-square framing, old knob-and-tube wiring); relocating plumbing or gas for a sink or range move; and the material grade of doors and slab. A written estimate from us lists cabinet line, slab, edge, demo, haul-away, permits if required, and labor separately. What isn’t included unless we scope it: appliance purchase, changing the floor, and moving a load-bearing wall or gas line.
See the difference
Before
After
Before
After
Before
AfterWhat Walnut Creek Homes Specifically Do to a Cabinet Job
Walnut Creek sits at the foot of Mount Diablo, so a lot of this work happens in the Ygnacio Valley and around downtown in 1950s – 1970s ranch and split-level homes. Those kitchens were laid out for a smaller fridge and fewer appliances, which usually means rerouting a circuit or adding an outlet when the new oven lands. Down in 94596 and 94597 we regularly hit plaster-over-lath walls rather than drywall, and cutting into that takes a different blade and more patching time.
The wildfire-zone overlay matters even indoors. If cabinet work touches a vent, a window assembly or anything on an exterior wall, Chapter 7A detailing comes into play, and we plan for it. We’re also careful about building inspections: cabinet replacement generally doesn’t need a permit, but adding an electrical circuit or moving gas does, and we pull it and pass it rather than asking the homeowner to sort it out.
Serving Walnut Creek, CA – Our Local Coverage Area
We serve Walnut Creek and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Cabinets & Countertops in Walnut Creek

Most jobs take about three weeks from demo to final walk, with two weeks of cabinet installation and roughly a week of countertop template, fabrication and install. Stone tops add the most time, and a plumbing or electrical change adds a day or two. Call (855) 471-4163 and we’ll give you a date range for your specific kitchen.
Straight cabinet and countertop replacement usually doesn’t need a permit. Adding an electrical circuit, moving a gas line or altering structure does, and we pull those permits and handle the inspection. Every estimate spells out which permits are included.
Yes, and most homeowners do. Keeping the sink, range and dishwasher where they are drops the price toward the $14,000 end and saves days of work. Moving the sink across the room means new plumbing, gas, possibly a structural change and a longer timeline.
Expect $14,000 to $45,000 for a full replacement. The value end is stock cabinets and laminate counters in a smaller kitchen; the top end is semi-custom or custom fronts, a natural stone slab and a plumbing move. Call (855) 471-4163 for an exact quote.
Cabinets and countertops are backed by our 730-Day Done Right Promise. If something isn’t right, we come back and fix it. Material warranties pass through from the manufacturer. No fine print on the labor side.
Ready for a Real Number on Cabinets & Countertops?
Call (855) 471-4163 for a free estimate on cabinets & countertops in Walnut Creek. A live person answers around the clock, and the first visit is an on-site measure and a design conversation, not a sales pitch. You’ll get a written line-item quote with the material sample, the permit scope and a start date. Many of these jobs are paired with a new island install or a wider project, so it fits neatly into Kitchen Remodeling in Walnut Creek if that’s where you’re headed. We handle the whole footprint across Walnut Creek, and our Kitchen Remodeling team coordinates trades if plumbing or electrical changes show up. If the old kitchen space is really part of a bigger plan, homeowners often pair this with Garage Conversion ADU in Walnut Creek or a New Detached ADU in Walnut Creek. We’ll bring samples and pull the permit if one’s needed.
Written by the team at Groundwork Construction Co.












