







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in San Leandro: What the Job Actually Takes
Paver driveways in San Leandro, CA typically run $7,000 – $18,000 and take 4 – 7 working days from demo to final compaction, depending on square footage and base depth. Here’s the honest version: most of that time isn’t spent laying pavers – it’s spent digging out the old slab or gravel, hauling it away, and building a base that won’t move when the clay under it does. Call (855) 471-4163 and we’ll walk your driveway, measure it, and put a real number in writing.
How we build it, stage by stage

Every paver driveway we install follows the same sequence, because skipping a stage is how driveways crack and heave two winters later. Here’s what each day looks like and where you need to make a decision.
Day 1 – Walk-through and layout. We mark the footprint, confirm drainage slopes away from the garage and foundation, and check the connection depth against your garage slab. You decide here whether we’re adding 12 inches of driveway width, cutting in a channel drain, or keeping the existing aprons. Measurements are final after this step, so this is the day to speak up.
Day 1 – 2 – Demolition and haul-off. We break out the old concrete or asphalt, load it into dumpsters, and expose the subgrade. On San Leandro flatlands lots, this is often where a surprise shows up: soft, settled soil that needs extra excavation. Expect one extra load and a half day longer if the base turns out deeper than planned.
Day 2 – 3 – Excavation and base prep. We dig to the depth that lets us lay 4 – 6 inches of compacted Class II base aggregate plus 1 inch of bedding sand. Each lift gets compacted with a plate or roller. Under the clay-rich soils common off Washington Avenue and the Marina flats, we sometimes add a woven geotextile fabric between subgrade and base to keep the two from mixing.
Day 3 – 5 – Laying pavers. Pavers go down in your chosen pattern, cut along edges with a wet saw, and get swept with joint sand. On a 400 – 600 square foot driveway, this is the fastest stage; on 1,000-plus square feet it stretches an extra full day.
Day 5 – 7 – Compaction, edge restraint, cleanup. We run compaction over the finished field, set edge restraint into concrete or spikes, re-sweep joints, and hose everything down. You do a final walkthrough before we leave. Any paver that rocks or sits proud gets lifted and reset in the same visit.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
- Concrete pavers (the standard choice): $7,000 – $18,000 installed. Strong, mold-resistant, takes a heavy load without shifting. The trade-off is that the color palette is more limited than clay brick and the seams between pavers show more on a slope. Belgard makes a solid line that holds up well to Alameda County heat cycling.
- Clay brick pavers: Higher cost per square foot, deeper color that doesn’t fade, and a classic drive that suits a 1950s Cherrywood ranch. Brick chips at edges more easily than concrete and needs a careful base to keep joints tight.
- Permeable pavers: Worth mentioning here because San Leandro’s wet winters and clay soils create runoff problems. Water seeps between and through the pavers into a gravel reservoir, so the drive drains instead of pooling against the garage. Cost runs toward the higher end of the range and needs a properly sized base.
- Pattern: Running bond is the fastest and cheapest to lay; herringbone and basketweave take longer and cost more but resist lateral creep on sloped drives. Most homeowners in the 94577 and 94578 ZIPs land on running bond with a soldier course border.
- A dummy joint or channel drain: A small add-on that prevents the exact failure we see after atmospheric river storms – water sheeting sideways under the garage door and into the slab.
What Paver Driveways cost in San Leandro, CA

Most paver driveway installations in San Leandro land between $7,000 and $18,000. A two-car drive of 400 – 450 square feet on a clean, well-drained lot sits near the bottom. Larger, sloped, or drainage-challenged drives push toward the top. Here’s what drives the number up or down:
- Size: Every 100 square feet of pavers adds roughly $1,500 – $2,500 installed, including base and sand.
- Existing condition: A thin asphalt layer over good base comes out cheap. A 6-inch reinforced concrete slab with rebar takes longer to demo and doubles haul-away cost.
- Base depth and soil: Clay subgrade that needs extra excavation, geotextile, or a stabilizing layer adds to both materials and labor.
- Material: Standard concrete pavers sit low; clay brick or permeable systems sit higher.
- Drainage and edge work: A channel drain, transition to a concrete apron, or tying into an existing curb adds a line item or two.
A written estimate should spell out square footage, base depth, material brand and color, edge restraint type, drainage handling, haul-away, and permit fees if applicable. What’s often left out of a competitor’s quote: base excavation beyond the baseline depth, soil disposal fees, and the compaction equipment. Ask. Our estimates are line-item and won’t change once work starts – the number you see is the number you pay, backed by our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat San Leandro homes specifically do to this job
San Leandro’s building stock is overwhelmingly 1950s and 1960s single-story ranch tract homes, and the Cherrywood and Washington Manor subdivisions mean we’re often tearing out driveways poured before most of our clients were born. Two things follow from that. First, the old slab is usually cracked near the garage apron because the expansive clay soils under the flatlands have been expanding and contracting for decades, and the “San Leandro lean” that shows up in home foundations applies to driveways too: uneven settlement means the new base has to be leveled and compacted in lifts, not just graded. Second, because drainage on these lots is tight and the marine climate brings wet winters with wind-driven rain, we slope every paver drive away from the house and add a channel drain where the apron meets the garage door. If the driveway is part of a bigger project – say a garage-to-ADU conversion or a full front-yard rework – it’s worth looking at our Driveway & Pavers in San Leandro page for how it connects to the rest of the scope. We cover the whole city, from the Marina district to the hills off Estudillo Avenue, through our San Leandro service area.
Serving San Leandro, CA – Our Local Coverage Area
We serve San Leandro and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Paver Driveways in San Leandro

Most drives are finished in 4 – 7 working days, with demo and base prep taking roughly half of that. A 400-square-foot drive is usually done in 4 days; larger drives on sloped lots stretch to 7. Call (855) 471-4163 and we’ll give you a schedule for your specific square footage.
If you’re replacing a driveway in the same footprint and slope, no building permit is typically required, but the work must not change drainage onto a neighboring lot. Cutting a new curb, widening the apron into the public right-of-way, or changing the grading toward the street can trigger city review and an encroachment process. We check the scope before we quote, and if a permit applies, we’ll tell you before we start and include it in the written estimate.
Pavers themselves rarely crack – the interlocking field flexes with the soil, which is one of the reasons they handle settling better than poured concrete. The base and edge restraint are what determine long-term performance. On the flatlands where clay moves with wet winters and dry summers, we build a deeper compacted base and use edge restraint pinned into concrete so the drive holds its shape. Call us for a walkthrough and we’ll tell you what your soil actually needs.
Yes, in most cases we work within the existing driveway footprint and protect landscaping with plywood and tarps during demo. If you want to widen the drive or add a border, that’s a decision to make at the day-one layout walk, because it changes the excavation and haul-off. Get an on-site walk from our team at (855) 471-4163 – the estimate is free.
Every paver driveway we install is covered by our 730-Day Done Right Promise – if it isn’t right, we make it right. That covers workmanship on base prep, compaction, pattern and edge restraint. Manufacturer warranties on pavers themselves run separately; we’ll hand you the paperwork at final walkthrough so you have it on record.
Schedule your Paver Driveways estimate
We’ll come out, measure the drive, check the slope and soil, and hand you a written line-item estimate at no cost. Calls are answered by a live person around the clock, and our technicians are background-checked and arrive in uniform. If your project also touches the front entry, homeowners often pair this with Door Installation in San Leandro or, for interior work, Cabinets & Countertops in San Leandro. Read more about our Driveway & Pavers work and financing options, including 0% for 18 months and $1,000 off projects over $10,000.
Call (855) 471-4163 for your free on-site paver driveway estimate in San Leandro.
Written by the team at Groundwork Construction Co.












