







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Pleasant Hill, CA: What It Costs and How Fast
A chain link fence in Pleasant Hill typically costs $3,500 to $9,000 installed, depending on lot size, height, and how much site work the property needs. Most residential runs are up in one to three days once permits are clear, with posts set on day one. Call (855) 471-4163 for a free on-site estimate at your 94523 address.
Key takeaways
- Typical Pleasant Hill chain link job: $3,500 – $9,000, site work and gate count drive the spread.
- Most runs: 1 – 3 working days, weather permitting.
- A simple fence permit is usually required; we pull it for you and pass inspection.
- Clay soil on the Diablo Valley slopes changes foundation depth and concrete volume more than the fence itself does.
How a Chain Link Fence Goes Up Here, Stage by Stage

Chaotic installs come from skipping steps. Here’s the sequence we follow on every chain link fence we build in Pleasant Hill, so you know what’s happening on your property and when.
Day 1 morning: layout and call-before-you-dig
We walk the property line with you, mark corners, gate posts, and any concern spots, then confirm the utility locator has flagged gas, water, and electrical before a single shovel hits the dirt. This is where you sign off on alignment – catch a fence on the wrong line before the holes exist, not after. Owners often pair a chain link run with new Door Installation in Pleasant Hill while the crew’s already mobilizing. Takes two to three hours.
Day 1 afternoon: demo, holes, and posts
Old fencing comes out, holes get dug to depth, and posts get set in concrete. On the expanding clay common on Pleasant Hill’s slopes, we widen and deepen footings more than flat-ground specs call for, because clay heaves with wet winters and shallow posts drift. You’ll decide post spacing and gate post bracing here. Three to five hours for a typical lot.
Day 2: concrete cure and rails
Posts cure overnight. We install top rail, tension bands, and line posts, then stretch fabric section by section. Curing is real: setting tension on green concrete cracks footings later. No decisions for you here beyond confirming gate swing direction (in or out). Full day.
Day 2 or 3: gates, tension, and walkthrough
Gates hang, latches and hinges get tuned, fabric gets tensioned and tie-wired. Then a walkthrough: every gate opens cleanly, no sagging, and you approve before we leave. If the job runs to a third day it’s because of gate hardware or a material short – we tell you, not surprise you.
After: inspection and punch list
If your permit requires inspection, we schedule it and pass it. Only then does the job count as done.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between on a Chain Link Fence
Chain link isn’t one product. These are the calls that change cost and lifespan:
- Gauge and coating: 11.5-gauge galvanized is the workhorse for most residential runs; heavier 9-gauge suits gates and high-traffic corners. Vinyl-coated fabric (green or black) costs more but holds color and cuts glare.
- Height: 4-foot is common for garden and pool-area separation, 5-foot is the everyday property-line standard, 6-foot where privacy or code demands it. Each step up adds material and wind load.
- Gate type: Single swing gates are cheapest and simplest. Double drive gates need heavier posts and bracing. Self-closing hardware is required for pool barriers.
- Post and footing: Standard concrete-set posts, or deeper footing on clay-heavy slopes. This is where Pleasant Hill lots differ from flat inland sites.
- Terminations and tops: Tension wire vs steel top rail at the bottom, finish caps vs rails at the top. Rails hold up better to dogs and kids.
The honest trade-off: vinyl-coated lasts longer and looks better but runs a few hundred dollars more on a typical run. If you’re staying in the home long-term, it pays back. If you’re flipping or fencing a rental, galvanized gets the job done fine.
What Chain Link Fence Costs in Pleasant Hill, CA

Best case, straight run, flat lot, standard 5-foot galvanized: $3,500 – $9,000 installed. That’s the honest spread for a residential back or side fence here. The number climbs as each of these moves:
- Lineal footage: The single biggest driver. Doubling the run roughly doubles material and labor.
- Slope and soil: Clay-heavy Diablo Valley slopes need deeper footings and more concrete – realistically a few hundred dollars extra on the job.
- Gates: Each gate adds hardware, heavier posts, and bracing. Double gates cost more than single.
- Height and coating: 6-foot vinyl-coated runs to the high end; 4-foot galvanized 11.5-gauge runs to the low end.
- Demo and debris: Removing an existing fence and hauling it away adds labor. Sometimes the old fence is a homeowner’s own.
- Permits: A fence permit here pulls the number up modestly – but skipping it costs more at resale or inspection.
A written estimate lists lineal feet, gauge, coating, post spacing, number of gates, footing depth, demo and haul-off, permit, and inspection as separate line items. What’s not included unless stated: tree removal, utility relocation beyond standard locates, or grading that wasn’t visible on the site walk. We say so upfront, not after. If you’re also considering a larger backyard project, this is often part of a full Fence Installation in Pleasant Hill scope, or you can see our broader Fence Installation service for the full picture.
See the difference
Before
After
Before
After
Before
AfterWhat Pleasant Hill Homes Specifically Do to This Job
Pleasant Hill is a built-out, almost entirely post-WWII Contra Costa suburb, so fencing work here is overwhelmingly replacement and repair – not new-lot installs. Most of 94523 is 1950s – 1970s single-story ranchers and split-levels on generous lots, plus condo clusters near downtown. That lot size is a gift for fencing but comes with its own surprises: original fence lines set decades ago sometimes don’t match the recorded property line, and we’ve seen more than one Gregory Gardens homeowner discover a boundary issue mid-job. The City’s tight hillside and creek-side review overlays mean fences near those edges can trigger drainage or design-review questions a flat-lot fence never does. The hot, dry summers and mild, wet winters in this inland Diablo Valley pocket are the other factor: winter rain saturates the clay and heaves shallow posts, which is why we go deeper on footings here than contractors do in flatter neighboring towns. For the Pleasant Hill customer, the failure mode we see most is sagging posts and rusted fabric on a fence that was set too shallow fifteen or twenty years ago.
Serving Pleasant Hill, CA – Our Local Coverage Area
We serve Pleasant Hill and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Pleasant Hill

Most residential chain link fences go up in one to three working days once permits are clear. Weather extends that, since winter rain softens the clay and we won’t set posts in saturated ground. Call (855) 471-4163 for a realistic timeline at your address.
Yes, most residential fence installations in Pleasant Hill require a permit, and we pull it and pass inspection as part of the job. Height and setback rules apply, and fences near creek-side or hillside overlays get extra review. We’ll tell you what your lot needs at the estimate.
In most cases yes, but not always cleanly. We call the utility locator before digging, and we route around established trees and irrigation. Gas, water, and electrical lines within the fence line may need a small adjust – we flag it before we dig.
Chain link fence in Pleasant Hill typically runs $3,500 to $9,000 installed, with height, gate count, lineal footage, and footing depth driving the spread. Vinyl-coated fabric and double gates push toward the high end. Call (855) 471-4163 for an exact quote – estimates are free.
Yes. Every chain link fence we build is covered by the 730-Day Done Right Promise – if something’s not right, we make it right. Our technicians have up to 12 years of experience, and we’ll put the warranty in writing before we start.
Get a Free Chain Link Fence Estimate in Pleasant Hill
Call (855) 471-4163 and we’ll schedule a free on-site estimate at your Pleasant Hill property. We walk the line, measure, talk through gauge, coating, and gate options, and hand you a written line-item quote with the price you see being the price you pay. No pressure, no surprises. If your project also involves utility trenching or site work for an accessory structure, homeowners often pair this with our ADU Site Prep & Utilities in Pleasant Hill crew. We cover the whole Pleasant Hill area and answers are live, 24/7.
Written by the team at Groundwork Construction Co.












