







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Orinda, CA: What It Takes and What It Costs
Door installation in Orinda typically runs $650 to $3,200 per door installed, depending on whether you’re hanging a prehung interior door, a solid-core exterior door, or a custom wood carriage door built to match your home’s original millwork. Most single-door projects finish in one day; a full-house door package takes three to five days. Call (855) 471-4163 for a free on-site estimate.
How We Run a Door Installation From First Measurement to Final Swing

Door work looks simple until you pull a jamb out of a 1960s Orinda wall and find the rough framing is two inches out of plumb. That’s why we run every door project on the same five-stage sequence, and why we don’t quote a firm number until we’ve seen the opening ourselves.
Stage 1: Site walk and measurement (about 60 to 90 minutes). We check every opening for square, level, and true wall thickness, and we look at what’s behind the trim: old shims, previous patches, water staining at the threshold. The homeowner decides at this stage whether a given door stays in place or gets replaced, and whether we’re matching existing casing or replacing it.
Stage 2: Written quote and product selection (two to four days out). You get a line-item estimate covering the door unit, hardware, trim, labor, and disposal. This is when you pick door style, material, finish, and hardware. If you’re ordering a custom wood door or a carriage-style exterior, lead times can run four to eight weeks, so we confirm that before scheduling.
Stage 3: Demo and opening prep (two to four hours per door). We pull the old door and jamb, inspect the rough framing and any rot at the sill or threshold, and repair or sister framing where needed. On Orinda hillside homes we pay close attention to the sill area on exterior doors, where moisture and slope drainage cause more failures than anything else.
Stage 4: Install, shim, and hang (three to five hours per door). New door goes in, shimmed and anchored, checked for plumb and a consistent reveal all the way around. Weatherstripping, threshold, and hardware go on next. We set latches so the door closes with light pressure from one finger, no slam required.
Stage 5: Trim, finish, and walkthrough (two to three hours plus dry time). Casing and trim go on, nail holes get filled, and we walk the finished work with you. If the door needs paint or stain, that’s a separate step and we tell you the dry time up front so you’re not stuck with a door you can’t close for two days. Every install carries the 730-Day Done Right Promise: if a hinge sags or a latch fails to line up, we come back and fix it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Orinda’s housing stock is mostly mid-century custom and ranch homes, which means door selection here is rarely about picking the cheapest option off a shelf. It’s about matching a 1950s or 1960s aesthetic without sacrificing modern weather performance. Here’s the honest trade-off on each choice.
- Solid-core wood vs. hollow-core doors: Solid-core costs $150 to $400 more per door but gives you the weight, sound dampening, and feel that matches Orinda’s higher-end homes. Hollow-core works fine in closets and utility spaces; skip it for bedrooms and any door on a noisy hallway.
- Custom carriage and wood doors: For front entries and detached structures, a custom wood carriage door is often the right call, but expect $1,800 to $4,000 and lead times of six to ten weeks. The trade-off is maintenance: wood needs refinishing every three to five years in East Bay hills climate.
- Fiberglass vs. steel exterior doors: Fiberglass resists the hot, dry summers and thermal movement better and won’t dent like steel. Steel costs less up front but shows dings in high-traffic entries and can rust at the threshold if water pools.
- Prehung vs. slab doors: Prehung doors (frame included) install faster and hold alignment better. Slab doors save money only when the existing jamb is in genuinely good shape. On older Orinda homes, we find the jamb itself is usually the weak point.
- Smart locks and integrated hardware: Keypad and app-connected deadbolts start around $200 and go up from there. They work well, but we check door thickness and backset before you buy, because some older doors need a small adjustment to fit the hardware properly.
What Door Installation Costs in Orinda, CA

Interior door installation runs $650 to $1,400 per door, installed. Exterior door installation runs $1,100 to $3,200 per door. A full-house interior door package (eight to twelve doors) typically lands between $6,500 and $14,000, and custom wood entry or carriage doors push well above that range.
Five variables move the number:
- Door material and grade: Hollow-core interior doors sit at the low end; solid-core wood, fiberglass exterior, and custom carriage doors sit at the top.
- Opening condition: Rot at the sill, out-of-square framing, or old shims that need to be rebuilt all add labor. A clean opening installs in three hours; a rough one takes five.
- Hardware and finish: Standard passage hardware versus smart locks, integrated deadbolts, or decorative lever sets can shift the per-door cost by $100 to $400.
- Trim and casing: If you’re matching existing 1950s casing, custom milling adds cost and time. Standard casing keeps the job lean.
- Permit scope: A single like-for-like interior door swap typically doesn’t need a permit. An exterior door that changes the opening size, or any door that’s part of a larger structural change, may require one. We confirm before we order anything.
Every written estimate covers the door unit, hardware, labor, trim, and haul-away of the old door. It does not cover paint or stain finish, which we quote separately, or underlying framing repairs that only become visible after demo. We flag that possibility before the job starts so the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Orinda Homes Specifically Do to This Job
Orinda is a semi-rural, heavily wooded Contra Costa hills town, and that changes door work in ways it doesn’t in flatter East Bay cities. On steep lots, the exterior door isn’t just a door: it’s a threshold between your interior and winter rain saturating clay slope. We regularly find sill rot on north-facing exterior doors in hillside homes where drainage was never properly directed away from the foundation. On the fire-safety side, exterior door upgrades often get reviewed alongside Wildland-Urban Interface requirements, and if your project touches the footprint of the house, tree-preservation and arborist review can affect the scope before a permit gets pulled.
The housing stock matters too. Orinda’s mid-century custom and ranch homes often still have original single-pane glass in exterior doors and original interior doors that have shifted with decades of hillside settlement. In the Sleepy Hollow and Glorietta areas, we commonly see door frames that have moved a quarter inch out of square, which means prehung doors need extra shimming and patient adjustment. If your door installation in Orinda is part of a bigger envelope upgrade, it reads naturally as Windows & Doors in Orinda, and homeowners often pair this with Cabinets & Countertops in Orinda during a larger interior refresh. For an ADU or garage conversion, we often handle door work alongside a Garage Conversion ADU in Orinda. You can see the full scope of what we cover through our Windows & Doors service, and we handle projects across Orinda and surrounding hills communities.
Serving Orinda, CA – Our Local Coverage Area
We serve Orinda and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Orinda

A single door installs in one day, usually three to six hours of on-site work. A full-house interior door package takes three to five days, and a custom wood or carriage door adds four to ten weeks of lead time before install day. Call (855) 471-4163 to schedule your free estimate and get a timeline for your specific openings.
Like-for-like interior door replacement typically doesn’t require a permit. Exterior door replacement that changes the opening size, or any door tied to a structural change, may require one, and Orinda’s hillside and WUI review can add steps if the project touches the building footprint. We confirm permit requirements before ordering product.
Yes, in most cases. Standard door replacements stay within the existing opening, so plumbing and framing don’t move. If your door is part of a larger wall change, we scope that separately and pull the right permits before any framing gets touched.
Custom wood carriage and entry doors typically run $2,500 to $4,000 installed, depending on material, hardware, and whether the opening needs framing work. Call (855) 471-4163 for an exact quote. Estimates are free, and we’ll walk you through the material options before you decide.
Every door we install is backed by our 730-Day Done Right Promise: if a hinge sags, a latch drifts, or the installation isn’t right, we come back and make it right. That warranty runs for two full years after the job is finished.
Get a Free Door Installation Estimate in Orinda
If you’re replacing a front door, upgrading interior doors, or installing a custom carriage door on an Orinda property, start with a free on-site estimate. Call (855) 471-4163 and a live person answers, day or night. We’ll walk your openings, talk through material options, and give you a written line-item quote covering door, hardware, labor, and trim. No pressure, no surprise numbers later.
Written by the team at Groundwork Construction Co.












