







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Orinda, CA: What It Costs and How Fast It Goes In
A chain link fence in Orinda typically runs $3,500 to $9,000 installed, and most residential lots finish in two to four working days once the layout is staked and the permit (if one is needed) clears. The number moves with run length, terrain, and gate count more than anything else. Call (855) 471-4163 and we’ll walk your lot line with you, price it on the spot, and put the figure in writing before anything gets dug.
How a Chain Link Fence Goes In, Stage by Stage
Chain link is the least glamorous fence we build and the most forgiving of Orinda’s terrain, which is exactly why it survives here. The sequence is short but the order matters, especially on a slope.
- Day 1, walk and stake. We mark the property line against your plat or survey, flag the tree protection zones the city cares about, and confirm gate placement with you. This is the meeting where you decide hinge side and swing direction. Any fence we install is part of a larger property plan, and if it’s part of a full Fence Installation in Orinda scope we sequence it so it doesn’t fight the rest of the work.
- Day 1 or 2, utility locate. Before a single post hole is dug, the 811 locate ticket gets called. On Orinda’s older lots the irrigation lines and old septic laterals are often where nobody remembers them being. That locate is free and non-negotiable.
- Day 2 and 3, dig and set posts. Terminal posts get concrete footings; line posts get driven or set depending on soil. The East Bay hills clay is hard as rock in August and soupy in February, so footing depth and concrete mix get adjusted for the season you’re building in. Posts cure before anything hangs on them.
- Day 3 and 4, rails, mesh, tension. Top rail, tension wire or bottom rail, then the mesh gets stretched and tied. Gates go on last, with the hardware adjusted so they latch clean and swing without dragging.
- Final walk. We pull the site clean, haul off spoils, and walk the fence with you. Then the 730-Day Done Right Promise is on paper: if a post leans or a gate sags, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Chain Link Options You’ll Actually Choose Between
Most of the decisions happen before day one, and each one has a real trade-off rather than a “premium is better” answer.
- Galvanized vs. vinyl-coated. Bare galvanized is the cheapest per foot and the most honest-looking for a utility line; it weathers to a dull grey. Vinyl-coated (usually green or black) costs roughly 15 – 25% more and reads better against landscaping and a hillside backdrop. On an Orinda lot where the fence line runs through redwood and oak, black or dark green disappears in a way bare steel won’t.
- Mesh gauge. Standard residential is 11.5 gauge; 9 gauge is heavier and holds up better if kids, dogs, or deer are hitting it. Heavier mesh costs more per roll but the labor is the same, so the upgrade is cheaper than it sounds.
- Heights. 4 ft for a boundary line, 5 ft for pets and pools, 6 ft where you want real screening. Anything over 6 ft starts needing a conversation about wind load on an exposed hilltop.
- Gates. A walk gate and a drive gate are two different builds. Drive gates need heavier frames and proper bracing; on a sloped driveway the swing clearance and grade change get measured before the gate is ordered.
- Post footings. Driven posts are faster and cheaper; concrete-set posts are the right call on corners, gates, and anything on clay or fill. Most Orinda jobs end up a hybrid.
- Top rail vs. tension wire. Tension wire is cheaper and less stiff; top rail is what most people picture. On a long hillside run the top rail is worth the extra.
What a Chain Link Fence Costs in Orinda, CA

For a typical residential lot, chain link in Orinda lands between $3,500 and $9,000. That range covers most of what we build here, and a written estimate will land somewhere inside it once we’ve seen the property.
| Line item | Typical range |
|---|---|
| Basic 4 ft galvanized, 100 – 150 linear ft | $3,500 – $5,500 |
| 5 – 6 ft vinyl-coated, 150 – 250 linear ft | $5,500 – $7,500 |
| Heavy 9 gauge mesh upgrade | Adds 10 – 20% to material |
| Walk gate, installed | $300 – $700 each |
| Drive gate, installed | $900 – $2,200 |
| Concrete footings on corners and gates | $40 – $90 per post |
Five things push a job toward the top of the range: length and gate count, obviously; slope and terrain, because a fence that racks down a hillside takes more posts and more time; tree and root conflicts, since we can’t just cut through a protected oak’s root zone; old fence removal, which is a haul-off cost; and permit scope, if the run crosses into a review that needs it. What’s in a written estimate: labor, material, footing concrete, gates and hardware, haul-off, and cleanup. What typically isn’t: survey work if the line is disputed, retaining or grading beyond a few inches, and any landscaping repair once the fence is in.
See the difference
Before
After
Before
After
Before
AfterWhat Orinda Lots Specifically Do to a Chain Link Fence Job
This is the part that catches out-of-town contractors. Orinda is a semi-rural, heavily wooded Contra Costa hills town, and almost every project here starts with trees, slope, and fire clearance before the building itself. The city’s tree ordinance and hillside/WUI review can dictate where a fence line runs before a single post is set, and we’ve seen permitted layouts revised around a heritage oak more than once. Practically, that means we check what’s protected in your root zones before we stake, and we factor in Firewise clearance spacing, because a fence that crowds the defensible space around a 1960s ranch house can become a problem in a dry August. It also means winter work gets scheduled around saturated clay on the steeper lots. Zip code 94563 covers all of it, from the wooded streets above the reservoir to the flatter lots near downtown. If your project also involves utility runs or grading, homeowners often pair this with ADU Site Prep & Utilities in Orinda so the underground work and the fence line happen in the right order. And if gates are getting upgraded, some folks pair this with Door Installation in Orinda at the same time.
Serving Orinda, CA – Our Local Coverage Area
We serve Orinda and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Chain Link Fence in Orinda

Most residential chain link jobs in Orinda finish in two to four working days once work starts. Permit review, if your run needs it, can add a week or more on the front end, and winter rain on the steeper lots can push scheduling. Call (855) 471-4163 for a tighter date once we’ve seen your property.
It depends on height, location on the lot, and whether the fence sits in a tree-protection or WUI zone. We pull what’s required and pass inspection, and we’ll tell you upfront if your run needs approval before we build. Call (855) 471-4163 and we’ll sort it out during the estimate.
Yes, and it’s common here. We route around the root protection zone rather than through it, which sometimes means a jog in the fence or a slightly shorter run. That’s usually a small cost addition, not a redesign. Call (855) 471-4163 to walk the line with us.
Plan on $3,500 to $9,000 for a typical residential lot, with gates, slope, removal, and grading decisions moving the number. Our written estimate is a fixed number, no change orders, and we offer 0% financing for 18 months plus $1,000 off projects over $10,000. Call (855) 471-4163 for an exact quote, free on site.
Every chain link fence we build is covered by our 730-Day Done Right Promise. If a post shifts, a gate sags, or the install isn’t right, we come back and make it right inside that window. Call (855) 471-4163 if you’d like the terms in writing before we start. Our technicians have up to 12 years of experience, and background-checked uniformed technicians work every job.
Get a Written Chain Link Fence Estimate in Orinda
If a chain link fence is on the list for your Orinda property, call (855) 471-4163 and we’ll set up a free on-site estimate. We’ll walk the line, price the run in writing, flag any permit or tree issues before they become surprises, and leave you with a fixed number and a 730-Day Done Right Promise. We cover Orinda and the surrounding neighborhoods, and our Fence Installation crews handle everything from a single boundary run to a full property line rebuild.
Written by the team at Groundwork Construction Co.












